Ring sling tummy to tummy
Step 1: Place rings over preferred shoulder, with placement just below shoulder in corsage-position. Sling should extend across chest like a sash, from shoulder to opposite hip.
Step 2: Start with baby in high-burping position on opposite shoulder of rings, with baby above fabric sash.
Step 3: While continuing to hold baby, reach through fabric sash with other hand and welcome baby’s legs one at a time, lowering baby down to a tummy-to-tummy position.
Step 4: Sit baby on bunched material of the sling, settling baby in a seated squat position.
Step 5: Pull fabric up baby’s back, up past the baby’s neck to fully extend the “pouch” from knees to the neck.
Step 6: Tuck fabric under the baby’s bottom, and pull up between baby and wearer to encourage a deep and secure seat within the sling.
Step 7: While still supporting baby under the bottom, tighten along the width of the fabric to remove excess slack in the sling. Use the tail of the sling to pull up and out, starting at one side of the tail and working across the width to the the other rail.
Step 8: Continue tightening until fabric tension is tight and even and snug across the back of baby and wearer.